Realtime Soft Forum

Forums -> UltraMon™ -> mirroring fails to start.

Dan Mirkin 2008-05-15 10:05

fails to start"Failed to set up mirror Target monitors. Restarting should fix this problem."

I want to have an eye chart program that is full screen on monitor two mirrored to monitor one in a smaller size. I get the above message though. Both monitors are plugged into the one Visiontec Radeon 9200 card. One is on digital output and the other is on the VGA output.

Dan Mirkin OD

Christian Studer 2008-05-15 15:00

You could get this error if you're trying to mirror the secondary monitor on the primary instead of the other way around.

Changing the mirroring settings so that the primary gets mirrored on the secondary monitor should fix the problem.

Christian Studer - www.realtimesoft.com

Forums -> UltraMon™ -> mirroring fails to start.

Post Reply