|
Post Reply
Towelie 2005-12-13 09:08
Ultramon isn't detecting my tv on my 6600gt..
I only have 1 monitor plus the tv, and I can use clone or horizontal/verticle span wiht my tv/monitor.. But ultra mon dosen't see the tv, or make any changes to it..
I'v rebooted and messed around a little bit with settings, still no luck.. In ultra mon in the ignore section, with both monitors on, it just shows 1 monitor with it like in wide screen..
|
Christian Studer 2005-12-14 01:49
Switching to Dualview mode will fix this, the problem is that in span mode both monitors appear as a single large monitor to UltraMon.
To change to Dualview mode, go to Display Settings and open advanced properties for the primary monitor, select the Nvidia tab, then select nView Display Settings and set nView Display Mode to Dualview.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
