|
Post Reply
PCGUY 2004-02-25 15:53
I went to set up my dual screen savers, and as soon as it trys to preview them in the little monitor picture it goes very very SLOW, and after about 20min of waiting I got it set so I tryed to use my screen saver, it poped on then it was SLOWWW again! It took about 10min to get out of the screen saver. The screen saver is just 3D pipes. Any chance my Folding@Home client running at lowest possibal priority might effect this? I had to bump up the priority on my taskbar to get it to run smoothely. If so how would I bump this up?
The Spud Cannon Database
|
PCGUY2 2004-02-25 15:59
OK I disabled my Folding@Home client and it worked fine, now how do I bump up the priority on this screen saver?
The Spud Cannon Database
|
Christian Studer 2004-02-25 21:31
I'm not aware of a way to change the screen saver process priority, Windows always runs the screen saver at lowest priority.
It would be possible to override the default priority setting in UltraMon though, this feature will be considered for UltraMon 3.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
